Formax 7100 Series - Manual (Page 45)

44
8. dOCUMeNT OrIeNTaTION TaBLeS
Paper orientation on the feed hoppers will depend on fold type, accumulation tray, OMR/Bar-
code and feed sequence. The example below shows how to reference the required orienta-
tion from the tables. Note that for most applications, the LEDs on the rear edge of the tower
folder will indicate the required orientation.
Fold Chosen is top address ‘C’
fold.
1. Select configuration from table
1. Note column A (unshaded).
2. OMR or Barcode? If NO, use
table 2. If YES, use table 3 for
OMR, table 4 for Barcode. Daily
Post (table 5) is not an option for
this fold type.
See following page for tables
2 - 5.
3. For chosen table, use row A
(from step 1). This indicates ori-
entation, feed sequence and read
head position (where applicable).
Note that for Daily Post, only
configurations in table 1, column
B can be used.
Fold generation requires:
Foldplate 1 set to 1/3rd paper
length Foldplate 3 set to 1/3rd
paper length
Preferred fold configurations are indicated bold and
give correct address orientation in window of standard
envelopes.
Shaded areas denote folds that give incorrect address
orientation in window of standard envelope. Reverse
printing and/or non-standard window envelopes may
permit use.
Note: For some complex jobs, not all paper trays may
be loaded in the same way.
example
