Formax 7100 Series - Manual (Page 35)

34
Tower folder - curled forms stop
Documents that are slightly curled may not feed properly, as the leading edge may become
snagged at the infeed. To help overcome this, each hopper tray is fitted with a 2-position
stop that can be raised or lowered.
1. Withdraw the hopper and pull both of the spring-loaded knobs outwards.
2. For flat forms or forms curling upwards, select the upper (default) position.
3. For forms curling downwards, select the lower position.
4. Ensure both knobs are properly located before replacing the tray.
6.2 Loading the envelope hopper
Pull the weighted roller back and load the envelopes, en-
suring they are fully down - flaps must be facing forwards.
Release the weighted roller so that it ‘tips’ the envelopes
into the pickup roller. An alternative heavier roller is also
available (part no. C3656A) which can improve feeding of
thick booklets. This must be fitted by an Authorised Serv-
ice Engineer.
Slacken the lock- le-
ver and adjust the side
guides to give 1 - 2mm
clearance across the
width of the envelopes.
Tighten the lock lever.
Raise or lower move-
able stop
Pull both knobs
out together