Formax 7100 Series - Manual (Page 16)

15
5.4 running a job
The Run Job menu shows the currently available jobs that have previously been pro-
grammed (or you can run the last job from the Main menu).
Highlight the required job and press  to reach the status box, showing the machine is
currently stopped. If using Select & Go, just press  , otherwise press the Start button and
the machine will perform a double document calibration cycle and then stop, displaying the
screen shown below.
As the calibration is performed on each loaded hopper, check the filled envelope to confirm
that only one document per hopper has been fed. If in doubt, select ‘Recalibrate’. Also check
the address position in the envelope - if it is too far up or down, this can be adjusted to suit.
Positive numbers move the address upwards. If you adjust the position, select ‘Recalibrate’
to check it is now correct.
If required, the job can also be edited from this screen (see page 16 for full details of edit-
ing a job).
When you are satisfied, select ‘Done’. Press the Start button and the machine will
begin running. Use the Up / down buttons to adjust the speed if required.
 The graphic indi-
cates which hop-
pers are active,
and whether a
folded document
or an insert.