Formax 7100 Series User Manual

Page 25

template:

doubles det.

Detects for double documents. On by default. Deselect only if you are

using unusual stationery that may cause spurious errors (eg. some

sheets heavy, dark text and some almost none).

deskew

Straightens a document if it is skewed. Options are Off/ Low / Me-

dium / High. If deskew is selected, note that the operating speed is

slowed; a setting of ‘High’ will slow the machine more than ‘Low’.

Select Hopper

You can decide where on the machine this hopper will be located. If

selected, you will move to further settings (see below) when you have

finished in the above screen.

Save as Temp.

Saves these settings as a template. If selected, you will move to fur-

ther settings (described later) when you have finished in this screen.

Note: If you wish these settings to be default, see ‘Supervisor Mode’ on page 30.
When all options for #2 have been set, select ‘Done’. Depending upon your settings, further

choices may now need to be made, as decribed below.

Mark reading:
If this was set to OMR or Barcode, the appropriate settings screen will then be displayed.

See page 27 for details of OMR setting, page 29 for Barcode settings.
Select Hopper:
If this was selected, the following screen will be displayed, allowing you to choose which

hopper this item is to be fed from, instead of using machine default. Note that the selected

hopper will be highlighted in the graphic. Select ‘Done’ when finished to return to the edit

screen.

Save as

If this was selected, the following screen will be displayed, allowing

you to save the edited item as a template for future items. Up to four

templates can be defined, and when all are used, you must replace

an existing template to save the new one.