Fluke Biomedical 10100AT - Manual (Page 3)

i
Table of Contents
Section 1: General Information ...................................................................... 1-1
1.1 Introduction .................................................................................................. 1-1
1.2 Features....................................................................................................... 1-1
1.3 Manual
Addenda.......................................................................................... 1-2
1.4 Before You Start – Safety Precautions ........................................................ 1-2
1.5 Safety Symbols and Terms.......................................................................... 1-2
1.6 Specifications............................................................................................... 1-3
1.7 Unpacking
and Inspection............................................................................ 1-8
1.8 Getting Started............................................................................................. 1-9
Section 2 : Operation ..................................................................................... 2-1
2.1 Introduction .................................................................................................. 2-1
2.2
Front Panel Familiarization .......................................................................... 2-1
2.2.1 Control Buttons....................................................................................... 2-2
2.2.2 Display.................................................................................................... 2-3
2.3 Connector Familiarization ............................................................................ 2-3
2.3.1 Ion Chamber Connector ......................................................................... 2-4
2.3.2 kVp Divider Connectors.......................................................................... 2-4
2.4 Power-Up Self-Test and Display Messages................................................. 2-4
2.5 Using the Options Button ............................................................................. 2-5
2.6 Basic Measurement Techniques.................................................................. 2-6
2.6.1 General Considerations.......................................................................... 2-6
2.6.2 Making Exposure Measurements ........................................................... 2-9
2.6.3 Making Exposure Rate Measurements................................................... 2-9
2.6.4 Use of the Model 35050AT Dosimeter as a kVp Divider Readout ........ 2-10
2.7 Simultaneous Measurement Mode ............................................................ 2-13
2.7.1 Making Combined Exposure Rate and kVp Measurements ................. 2-13
2.7.2 Making Combined Exposure, kVp, and Time Measurements............... 2-13
2.7.2.1 Advanced Measurements Options .................................................. 2-14
2.7.2.2 Time Corrections............................................................................. 2-14
2.7.3 Making kVp and Time Measurements Without an Ion Chamber .......... 2-14
2.7.4 Making Exposure or Exposure Rate Measurements Without a Model
35080/80A/80B kVp Divider ................................................................. 2-15
2.7.4.1 Advanced Measurements Options .................................................. 2-15
2.8 Exclusive Measurement Mode................................................................... 2-16
2.9 Using the Ion Chamber Test Stand and Accessories ................................ 2-17
2.9.1 Using the Test Stand for Over-Table Tubes ......................................... 2-18
2.9.2 Using the Test Stand for Under-Table Tubes ....................................... 2-19