Floscan Series 9700/97000 Standard Flow GPS Interface System (twin engine model) - Manual (Page 6)

5/14/2007 4001-386-00I
FloScan Instrument Company, Inc. Tel: (206) 524-6625 Fax: (206) 523-4961
3016 NE Blakeley Street, Seattle, WA 98105 Email: [email protected] Http://www.floscan.com
Installation Do’s & Don’ts
Do Don’t
Always use a Fuel Proof Pipe Thread Sealant
when assembling fittings into fuel system
components, (Locktite PST, Rector Seal, or
equivalent).
Never use Teflon Tape!
Use thin wall, low pressure, full flow type
NPT or NPTF hose barb fittings.
If possible avoid using Push-Lok, Barb-Tite,
JIC or SAE swivel fittings. If used, always
install
Copper AP-50 sealing washers or Flaretite
fitting seals onto JIC and SAE swivel fittings.
Double clamp all hose barb fittings. Minimize the use of 90º elbow fittings.
Install Sensors as far from the engine as practical.
Fuel must travel, “Up-hill” at least 1 or 2 inches
after leaving the Diesel Return Sensor, and all
Gasoline Sensors. Verify correct orientation and
fuel flow direction.
Avoid bolting or mounting
sensor(s) directly onto the engine.
Always install Diesel Forward Sensor/Pulsation
Damper assemblies and Gasoline Sensors in the
Fuel Pump’s Inlet or Vacuum line.
Limit Sensor/Pulsation Damper assembly
Operating Pressure to 20 PSI or Less.
Try to use A-1 Fabric Braid Fuel Hose. If possible avoid using steel braid,
“Aeroquip” type hose, hard pipe or metal tube.
Always use 30-micron primary filters on Diesel
systems. 20 and 10-micron filters are also
acceptable if required by the engine manufacturer.
Avoid 2 or 5-micron primary filters.
Wire with Shielded Cable on Diesel installations.
If possible use a dedicated shielded wire pair for
Magnetic Pickup Tachometer Senders.
Never use unshielded wires on
Magnetic Pickup Tachometer Senders.
Connect all Negative wires to a Battery Minus
Buss or directly to the Battery’s Negative
Terminal.
Connect or, “Ground” wire shields / shield drains
to the engine block or vessel bonding system.
Never connect Negative, (Battery Minus) wires
to the Vessels Hull, Engine Block,
or other machinery.
On Instruments with a GPS interface, connect
FloScan’s Data (+) to the GPS signal output.
Connect Data (–) to a Battery Minus buss.
Do not connect FloScan’s Data (–)
to the GPS Data (–).
Always use non-illuminated switches for Totalizer
Reset, Port/Starboard Select, Hours/Synch, and
GPH/MPG .
Never use illuminated, or back-lit switches.