Floscan Series 9700/97000 Standard Flow GPS Interface System (twin engine model) - Manual (Page 18)

07/24/08 4001-443-00
FloScan
Additional
Flat Washers
If Needed
OR
Flat Washers
ESNA Nuts
Long Spacers
Lock Washers
1-1/4"
2-1/4"
2. Slide a lock washer onto two, 1¼” bolts.
3. Chose your 90° mounting bracket option. Assemble the
1¼” bolts through the angle and flat brackets into the
Pulsation Damper base.
4. Tighten the bolts a little past hand tight, compressing the
lock washers slightly.
5. Install the two long spacers between the Sensor body and
flat bracket.
6. Slide the two, 2¼” bolts through the Sensor body, spacers
and flat bracket.
7. Grasp the Pulsation Damper and hold the flat bracket
against the Pulsation Damper’s base. Verify that the
Sensor’s base is perpendicular to the flat bracket.
8. If the Sensor and spacers are flush with the flat bracket,
install flat washers and ESNA nuts onto the 2¼” bolt ends
and tighten until snug. The Pulsation Damper and Sensor
bolts should be tightened evenly.
9. If a small air gap is present between Sensor and spacers,
place one flat washer between each spacer and the flat
bracket.
10. Install flat washers and ESNA nuts onto the bolt ends and
tighten until snug. The Pulsation Damper and Sensor bolts
should be tightened evenly.
(Continued on next page)
MECHANICAL INSTALLATION
FloScan Instrument Company, Inc. Tel: (206) 524-6625 Fax: (206) 523-4961
3016 NE Blakeley Street, Seattle, WA 98105 Email : [email protected] Http://www.floscan.com