Floscan Series 9700/97000 Standard Flow GPS Interface System (twin engine model) - Manual (Page 15)

07/24/08 4001-443-00
1. Place the Forward Sensor-Pulsation Damper assembly, with
inlet and outlet fittings installed, onto the flat bracket. Orient
the Sensor body over the slots and the Pulsation Damper
base over the bolt holes.
FloScan
Additional
Flat Washers
If Needed
OR
Flat Washers
ESNA Nuts
Short Spacers
Lock Washers
1-1/4"
2"
2. Slide a lock washer onto two, 1¼” bolts.
3. Chose your 90° mounting bracket option. Assemble the 1¼”
bolts through the angle and flat brackets into the Pulsation
Damper base.
4. Tighten the bolts a little past hand tight, compressing the
lock washers slightly.
5. Install the two short spacers between the Sensor body and
flat bracket.
6. Slide the two, 2” bolts through the Sensor body and spacers.
7. Grasp the Pulsation Damper and hold the flat bracket
against the Pulsation Damper’s base. Verify that the
Sensor’s base is perpendicular to the flat bracket.
8. If the Sensor and spacers are flush with the flat bracket,
install flat washers and ESNA nuts onto the 2” bolt ends and
tighten until snug. The Pulsation Damper and sensor bolts
should be tightened evenly.
9. If a small air gap is present between the Sensor and both
spacers, place one flat washer between each spacer and the
flat bracket.
10. Install flat washers and ESNA nuts onto the bolt ends and
tighten until snug. The Pulsation Damper and Sensor bolts
should be tightened evenly.
(Continued on next page)
Return Sensor to Return Pulsation Damper Assembly
FloScan Instrument Company, Inc. Tel: (206) 524-6625 Fax: (206) 523-4961
3016 NE Blakeley Street, Seattle, WA 98105 Email : [email protected] Http://www.floscan.com