Fire Magic Aurora Built-In Combo Grill A830i - Manual (Page 28)

28
CONVERTING THE GAS TYPE
4. Remove the back panel by pulling the bottom toward
the front of the grill and rotating it upward and
outward until the two top tabs attached to back wall
of the oven can be removed from the slots in the top
of the plate.
5. R e m o v e t h e b a c k b u r n e r
assembly retaining screw on
the lower left of the backburner
u s i n g a P h i l l i p s - h e a d
screwdriver and set it aside.
6. Pull the backburner assembly
to the left, clear of the orifi ce,
and then rotate the top forward
and downward and lay it face
down across the cooking grids
or main burners.
CAUTION: B e c a r e f u l n o t
t o d a m a g e t h e
wires connected
to the backburner
assembly.
7. Use a 3 /
8
" hex nut driver
to remove the exposed
orifi ce and replace it with
the correct orifi ce for the
gas being conver ted to
(See Table 1 for size).
8. Replace the backburner assembly and reinsert the
retaining screw. Center the backburner assembly so
that the backburner plate will fi t over it. Tighten the
retaining screw using a Phillips-head screwdriver.
9. Replace the back panel by fi rst inserting the tabs
above into the slots in the top of the plate and then
rotating the bottom downward and inward.
10. Replace all the backburner plate screws using a
Phillips-head screwdriver.
6. Pull the wire from the ignitor
electrode (Fig. 28-2), then remove
the backburner retaining screw
on the left of the backburner
(Fig. 28-1) using a Phillips
screwdriver.
Fig. 28-2
Backburner
orifi ce Backburner
air shutter
Electrode
wire
Fig. 28-1
Retaining
screw
CHANGING AN INFRARED BURNER ORIFICE
(IF EQUIPPED)
1. Remove the cooking grid from above the burner on
which you are working by lifting it fi rst from the front
and set it aside.
2. Unscrew both lighting tube hex head screws with a
3 /
8
" hex nut driver.
3. Remove the infrared burner by lifting the back of the
burner up so that both tabs are freed from their slots,
then lift the burner toward the back of the fi re box
and upward. Set the burner aside.
4. Use a 3 /
8
" hex nut driver to remove the exposed orifi ce
and replace it with the proper orifi ce for the new gas
(see Table 1 for sizing).
5. Replace the infrared burner by fi rst sliding it over the
orifi ce, then lowering the two tabs under the back of
the burner into the slots in the back burner rest.
6. Reattach the lighting tube and replace the grid so
that the cut-out section is in front.