Lighting (ignition) instructions, Electronic lighting, Manual lighting – Fire Magic Aurora Built-In Combo Grill A830i User Manual
Page 19: 19 shutting off the unit, When using a portable propane tank, Charcoal grill

19
SHUTTING OFF THE UNIT
To shut off the unit, depress each valve control knob 
and while pressing turn it clockwise to the OFF position.
Always close the valve from the gas supply after each 
use of the unit.
ELECTRONIC LIGHTING
Note: Electronic lighting requires an installed 9-volt
battery with a good charge.
1. Open lid(s) or remove cover(s) from burner(s) to be lit.
2. Turn all gas control knob(s) to their OFF position(s).
3. Turn on the gas at its source.
Note: DO
NOT
t u r n o n m o r e 
than one valve at 
a time for either 
e l e c t r o n i c o r 
manual lighting.
4. Depress the desired control knob for 5 seconds,
then, while pressing turn it counterclockwise to the 
HI LIGHT position. Once the burner lights, release 
the knob.
CAUTION:
If a burner does not light within fi ve (5) 
seconds of turning on the control knob, 
depress the knob and turn it to the OFF 
position. WAIT FIVE (5) MINUTES 
before repeating step 4. If you smell 
gas, follow the instructions on the cover 
of this manual. If the burners still do not 
light after several attempts, refer to the 
instructions for manual lighting.
5. Repeat step 4 for each additional burner to be lit.
WHEN USING A PORTABLE PROPANE TANK
Propane tanks are equipped with a safety shutdown 
device that may cause low or no gas pressure/fl ame 
at the burners if operating and lighting instructions 
are not followed exactly (See important note in the 
TROUBLESHOOTING section for more details.) 
MANUAL LIGHTING
CAUTION: Always wait fi ve (5) minutes for gas to
clear after any unsuccessful lighting 
attempt.
1. Follow steps 1 through 3 (left).
2. Insert either a burning long-barrel butane lighter or
a burning long-stem match through the cooking grid 
opening to the top of the lighting tube. (Fig. 19-2). 
F o r b a c k b u r n e r s , h o l d t h e f l a m e 
a g a i n s t t h e s u r fa c e o f t h e b a c k b u r n e r. 
For sideburners, hold the fl ame against the burner.
3. Hold the match / lighter fl ame at the top of the lighting
tube for 5 seconds, or, next to the sideburner / 
backburner. Then depress the appropriate control 
knob and while pressing turn it counterclockwise to 
the HI LIGHT position. Remove the lighter or match 
when the burner lights, and release the control knob.
4. If the burner does not light, immediately depress
the knob and turn the valve to OFF. WAIT FIVE 
(5) MINUTES before repeating steps 2 through 4 
of the MANUAL LIGHTING instructions.
Read all instructions before lighting, and follow these instructions each time you light the unit.
Fig. 19-2
- Manual lighting
Lighter
Lighting
tube
Fig.
19-1
- Control knob
OFF
HI
LIGHT
LOW
T
O
TURN OFF
T
O
TURN
ON
Read setting
here
HIGH to 
LIGHT
Read setting here
(OFF position shown)
To
Turn
OFF
To
T
urn
ON
Use
HI (high) 
to light
Press 
knob in 
to turn
3. Hold the match / lighter fl ame at the top of the lighting
tube for 5 seconds, or, next to the backburner. Then 
depress the appropriate control knob and while 
pressing turn it counterclockwise to the HI LIGHT 
position. Remove the lighter or match when the 
burner lights, and release the control knob.
WHEN USING A PORTABLE PROPANE TANK
Propane tanks are equipped with a safety shutdown 
device that may cause low or no gas pressure/fl ame 
at the burners if operating and lighting instructions 
are not followed exactly (See important note in the 
TROUBLESHOOTING section for more details.
CHARCOAL GRILL
Remove the cooking grids and lower the charcoal tray all 
the way down. Pile your charcoal on the screen (avoid 
spillage). Light the charcoal burner using the charcoal knob, 
as described above. Allow it to burn for 5-10 minutes, or 
until the charcoal has independently lit. Then turn off the 
charcoal burner.
2. Insert either a burning long-barrel butane lighter or
a burning long-stem match through the cooking grid 
opening to the top of the lighting tube. (Fig. 19-2). 
F o r b a c k b u r n e r s , h o l d t h e f l a m e 
a g a i n s t t h e s u r fa c e o f t h e b a ck b u r n e r. 
For charcoal burners, hold the fl ame near the burner.
3. Hold the match / lighter fl ame at the top of the
lighting tube for 5 seconds, or, next to the 
sideburner / charcoal burner. Then depress the 
appropriate control knob and while pressing turn it 
counterclockwise to the HI LIGHT position. Remove 
the lighter or match when the burner lights, and 
release the control knob.
4. If the burner does not light, immediately depress
the knob and turn the valve to OFF. WAIT FIVE 
(5) MINUTES before repeating steps 2 through 4 
of the MANUAL LIGHTING instructions.
Note: This unit must be connected to 120VAC power
for electronic lighting.
LIGHTING (IGNITION) INSTRUCTIONS
