Fire Magic Aurora Built-In Combo Grill A830i - Manual (Page 24)

24
Drippings from grilling flow through specially
designed channels and collect in the drip trays.
Check the drip trays regularly and empty when
required.
Your grill includes a pack of four (4) Fire Magic®
drip tray liners (Fig. 24-1). For your convenience
in cleanup, place a liner into the drip tray (gas grill
side only) before grilling.
To fi t a liner into the drip tray, pull out the tray and
set it on a fl at, level surface. Place the liner in the
drip tray as shown in Fig. 24-2 and carefully insert
the tray back under the control panel.
Note: Be sure that the liner is properly placed into
the drip tray. The front of the liner must fi t
under the drip tray's lighting instruction plate
(see 24-3 detail).
After each use, wait for the grill to cool and carefully
pull out the drip tray to check it. When a liner is
nearing full, carefully lift it out of the drip tray, lifting
with both hands to keep the tray level until it is safely
discarded. Then insert a new drip tray liner.
Order more drip tray liners through your local Fire
Magic® dealer.
Note: The foil tray liner is also useful for setting on
burners to cover them and catch drippings
directly during rotisserie only cooking.
Note: For models with match holders attached
inside the drip tray, place the match holder
off to one edge of the pan (Fig. 24-3). If
necessary, mold the foil liner around them
and the other features of the tray to create
enough clearance space to open and close
the tray without catching the liner.
Fig. 24-1
Be sure liner fi ts under lighting instruction plate
Pull out the drip tray (gas grill side) and place liner
Fig. 24-2
Fig. 24-3
Note: There are easy to follow lighting instructions
etched onto the top of the drip tray handle.
CHARCOAL DRIP TRAY
After each use, wait for the grill to cool and carefully
pull out the charcoal drip tray to check it. When
nearing full, carefully pull out the drip tray, lifting
with both hands to keep the tray level until it is
safely discarded.
Note: The charcoal drip tray has a heatshield
to protect from over heating. It may be
necessary to remove the heatshield to
properly clean out the charcoal drip tray.
When reinstalling, the heatshield dimples
must face downward as shown in Fig. 24-5.
Pull out charcoal drip tray and discard
Fig. 24-4
Charcoal drip tray heatshield placement
Fig. 24-5
The grill serial identifi cation number is located
on the underside of the drip tray handle (gas grill
side). It is recommended that the drip tray fi rst be
removed and cleaned / emptied of its contents,
then turned over to view.
DIMPLES MUST FACE
DOWNWARD
FIRE MAGIC ® DRIP TRAY