Fire Magic 3046 Infrared Burner User Manual
Infrared burner

REV 2 - 1208201328
L-C2-155
1
ROBERT H. PETERSON CO. • 14724 East Proctor Avenue • City of Industry, CA 91746
FITS ALL FIRE MAGIC STAINLESS STEEL
UNIBODY GRILLS
The Fire Magic infrared (IR) burner is ideal for searing
and fast cooking where needed, and gives a more
intense heat than standard burners. Replacing 2 main
burners with the infrared burner is quick and easily done
by using the instructions set out below.
TO MAKE THE INSTALLATION OF THIS UNIT
TROUBLE FREE, READ THIS DOCUMENT
THOROUGHLY AND THEN CAREFULLY FOLLOW
THE INSTRUCTIONS GIVEN. OBSERVE THE
CAUTIONS LISTED ON THE BACK PAGE.
Note: Use your grill operating instructions to identify
par ts and locations mentioned in these
instructions.
1. When they are cool enough to handle, remove
cooking grids, and fl avor grids (if equipped).
2. Remove the face screws (Fig.
1-1
) & burner valve
knobs. Place aside for later use.
3. Pull out drip tray and carefully lift face away just
enough (about 4"- 6") to enable you to reach behind
face and disconnect the wires attached to the spark
ignitor (Fig.
1-2
). Set the face safely aside.
4. Remove the two burners, air shutters, and the
springs (Fig.
1-3
) that you will replace with the IR
burner.
Note: The two far left burners should be replaced.
For Elite, Monarch, and Deluxe grills, the ignitor box
must also be removed. For Elite, Monarch, and Custom
grills, the crossover box next to the burners must also
be removed.
INSTALLER:
Leave these instructions with consumer.
CONSUMER:
Retain for future reference.
INFRARED BURNER
2 series Model # 3046
1 series Model # 3047
Infrared burner (top view)
Removing:
Remove face screws
Move face away
slightly, then
remove the ignitor
wires
Face
Burner
Air
shutter
Important: READ THESE INSTRUCTIONS CAREFULLY
BEFORE STARTING INSTALLATION OR USE.
Fig. 1-1
Fig. 1-2
Fig. 1-3
Spring