ETA Bolero - Manual (Page 62)

ENG - 62
ENG
7.2 UsInG methoD & fUnctIonal statUs of the DockInG statIon
no. function Guide function Information
1 LED decorative light
Turn on the decorative light to activate the atmosphere, and place
in the glowing center of the light a little essence, which will give
off charming aroma after heating.
2
Decorative light
switch
Press the switch to turn on/off while the decorative light is on.
3 Power LED
The Power LED will light when the Docking Station is
connected with the power, or turn off if not connected.
4 Charging indicator
The indicator will flicker while the recharger is connected
with the cleaner.
5 Signal transmitting
Transmitting signal is the only way to lead the cleaner to return
the Docking Station for charging, so the signal transmitting
position should be clean for long without any obstacle on it.
6/7 Recharging positive
& negative electrode
The electrode and that of the Cleaner are connected to charge
under contact mode, so the position should be clean without any
obstacle on it while using, or there will be impact to the charging.
8
Charging power
DC socket
The power DC socket, called recharger for short, used to connect
output terminal DC 24V of the adaptor, is the charging transit
station between the Cleaner and adaptor, so the recharger should
be placed against the wall firmly and the adaptor cable should
be away from the recharger, or the Robot may have impact and
winding during cleaning.
Some essence may damage the plastic surface, so please make purchase and use after consideration.
8. space Isolator
8.1 DescrIptIon of space Isolator
overall Display function Instructions
1) Toggle switch
1) Turn off
2) Low
3) Middle
4) High
2) Signal head
3) Near - infrared transmitting head
4) Power LED
8.2 fUnctIon IntroDUctIon of space Isolator
Space Isolator, an accessory of the cleaner, can block area by sending special infrared signal
so as to prevent the Cleaner from entering some unnecessary areas.