ETA Bolero - Manual (Page 58)

ENG - 58
ENG
4.3 cleanInG of maIn brUsh anD floor brUsh:
1) Clear the hair or big dust particles on the brush and floor brush regularly to improve
the cleaning performance. Clean the dust at the air intake. Clean the wastepaper or small
particles by dust brush directly. Rotate the brush carefully and cut by scissors or pull by
hand the hair, yarn and other twisted objects.
2) The cleaning of the main brush and floor brush can be done by reference to the assembly
& disassembly.
4.4 assembly & DIsassembly anD cleanInG of left/rIGht Wheel anD front
Wheel
fig. o17
1) Release the screw of the left/right wheel by the screwdriver.
2) Take out the left/right wheel and clean them with the brush.
Don’t wash them in water!
3) Place the left/right wheel in the original position, and tighten the screw while assembling.
4.5 assembly & DIsassembly anD cleanInG of front Wheel:
fig. o18
1) Pull out the front wheel with your finger and tools and then clean it (Refer to the figure).
2) Insert and press the front wheel into the right position while assembling.
4.6 cleanInG of sensor anD InfrareD transparent WInDoW
1) Clean the sensor and infrared transparent window with the cotton swab or soft cloth.
2) The wall detection sensor is in front of the Cleaner, while the ground detection sensor
and infrared transparent window are at the bottom of the Cleaner.
3) Please keep the transparent window clean so as to make the Robot work better.
5. replacement of battery:
fig. o20
5.1 battery replacement of the cleaner:
1) Spin the pivot , open its base plate and then take out the battery.
2) Please place the positive and negative electrode correctly for fear of the damage due
to wrong electrode!
5.2 battery replacement of the space Isolator:
1) Release the screw with the screwdriver and then open its base plate
2) Please place the positive and negative Electrode correctly for fear of the damage due
to wrong Electrode!
3) The right place of battery.
4) Please take out the battery if it was unused for long.
5.3 battery replacement of the remote control:
1) Open the battery cover and then replace the battery
2) Please place the positive and negative electrode correctly for fear of the damage due
to wrong electrode!
3) Please take out the battery if it was unused for long.