ETA Bolero - Manual (Page 57)

ENG - 57
ENG
automatic charging:
The Cleaner will search the Docking Station for charging automatically in case of low battery
during cleaning, fig. O10.
1)
The Cleaner may fail to find the Docking Station due to the obstacle, decreased battery
and complex condition.
2) When the cleaner finish cleaning , the temperature of the battery is very high;
so charging time will be longer.
4. assembly & DIsassembly anD cleanInG of DUstbIn:
Important!
clean regularly the vacuum cleaner. In another case, may cause faulty vacuum cleaner
or damage.
assembly & Disassembly of Dustbin, fig o11:
1) Extract the dustbin by pressing the key on top.
2) Press the red button on it, and then the blower will pop up automatically.
3) Reverse the blower, release 2 fasteners and open the cover.
4) Open the bracket and the filter will appear, fig O12.
5) Change a new filter, press the semicircle bracket by one hand to release the fastener from
the filter screen, and remove the filter grid by the other hand and then change a new one o.
6) Reverse the dustbin, tear out the mop, release the trailing bar and then unplug the right
and left fasteners on the bottom of the dustbin (Refer to Figure O13). All parts should be
assembled as before disassembly.
Don’t use the mop and trailing bar on the carpet or uneven ground.
cleaning of dustbin, blower and dust senzors, fig. o14:
1) First dump the dust, and then clean it with Dust Brush. Also, clean the sensors for identify
the level of floor pollution, which are located on the sides of the dustbin (see arrow).
2) Pop up the blower, and then clean the air inlet/outlet with dust brush.
3) Don’t clean the blower in water!
4) Pop up the blower, take out the filter, and then clean the dustbin.
5) Clean the filter by hairdryer or Dust brush.
6) After cleaning, you can assemble it firmly as before the disassembly.
4.1 assembly & DIsassembly anD cleanInG of maIn brUsh anD floor brUsh
fIG o15
1) Force the locking bar forward and raise the cover by right thumb, and then raise rod
of the mid cleaning brush by your left hand.
2) Take out the main brush and floor brush.
3) Insert the main brush and floor brush into the holes before closing the cover in assembly.
4.2 assembly & DIsassembly of sIDe brUsh:
fig o16
1) Release the screw in the main shaft of the side brush before changing the side brush.
2) Press the side brush against the main shaft and then fasten the screw (Refer to the figure).