ETA Bolero - Manual (Page 56)

ENG - 56
ENG
3. InstallatIon of DockInG statIon anD charGInG for the
cleaner:
3.1 aUtomatIc recharGInG:
1) Install the Docking Station on the flat ground firmly and against the vertical wall (fixed
on the wall with the docking station sticker).
2) No obstacle 3 m away from the Docking Station in the front and 0.5 m on the right and left.
(Refer to Figure O5).
3) The Cleaner cannot search the Docking Station for charging if the infrared signal
transmitting window of the recharger is covered.
4) Connect the output terminal of the adaptor with DC socket of the Docking Station
Please put the power cord of the adaptor in order and place it along the wall, or it may
affect the automatic recharging.
3.2 manUal charGInG:
1) You can use the adaptor or Docking Station of the Cleaner to charge for the main body
directly.
2) Connect the output terminal of the adaptor with DC socket of the main body while using
the adapter for charging (Refer to Figure O6).
3) Before charging, connect the adaptor with the Docking Station , make sure the cleaner
abut against the Docking Station, and good touch for the electrode of Docking Station and
Cleaner (Refer to Figure O7).
Important InformatIon for fIrst Use!
• Recharge the vacuum cleaner battery to full capacity (don´t interrupt charging).
• Then turn on the vacuum cleaner and let it work until low battery power.
• Repeat this process five times. The above advices are for correct formatted battery and
extend battery life.
1) Press „ “ in the remote control if you want to charge for the main body, the Cleaner will
search the Docking Station for charging within available scope automatically
(Refer to Figure O8).
2) Press any key in host panel or POWER 0FF while the Cleaner is searching for the Docking
Station, the Cleaner will then stop searching.
3) After the battery is used up, the first grid of the charging icon will flicker, when the second
and then the third grid will flicker showing it is charging, stop flickering after completing
the charging (Refer to Figure 4 and Figure O9).
4) Turn on the Cleaner, full three grids show enough power, one grid missing means the
decreased power, and it should be charged after three grids missing.