Dakota Digital 3X - Manual (Page 16)

MAN 650067:G 16
Setting up the control box
Below is a list of all of the setup menus. You must have SW1 wired to enter setup;
descriptions of each menu are below. Pay close attention to Setup Menus and settings as
incorrect settings will cause faulty readings on the displays.
Main Menu Sub Menu Description____________________
SPEED
SENDER (NORMAL, BUS) Select sensor type
AUTO Auto calibrate speed
ADJUST Adjust the speed calibration
SERVICE (OFF, 500 – 7500) Select the service countdown
OUTPUT (2k PPM, 4k PPM) Select output speed signal PPM setting
DONE Exit setup menu
TACH
T CAL (BUS, 1 – 16 )))) Set engine cylinder count
UPDATE (SLOW, MID, FAST) Set rpm update rate
WARN (2200 – 14800) Set rpm shift warning point
SIGNAL (5 LO, 12 HI) Select rpm signal voltage level
DONE Exit setup menu
VOLT
WARN (10.0 – 13.1) Set low volt warning point
DONE Exit setup menu
WATER
SENDER (DD F,DD C,BUS F, BUS C) Select sensor type
WARN (150-300F / 65 -148C) Set high temp warning point
TEST Display sensor ohm reading
DONE Exit setup menu
OIL
SENDER (NORMAL, BUS) Select sensor type
WARN (5 – 36) Set low pressure warning point
TEST Display sensor ohm reading
DONE Exit setup menu
FUEL
SENDER (SW 33, CUSTOM, Select sensor type
GM 30, GM 90, GM 250,
F 10, F 150, V 180, BUS)
CUSTOM Calibrate custom fuel sensor
TEST Display sensor ohm reading
DONE Exit setup menu
PERF
On On On On Enable performance readings
Off Off Off Off Disable performance readings
NIGHT Change preset night dimming
BIM
SCAN Check/scan for connected modules
SETUP Enter setup (only when modules present)
DONE Exit setup menu
INFO
SE SE SE SE xx Current software code on speed display
SPEED CAL PPM on press/hold
GEAR
OVRDRV Will show gear position with overdrive at the
bottom of message center
NONE No gear position shown
PRND21 Will show gear position at bottom of Message center
-ODOM Used to preset odometer reading
To enter the setup mode, press and hold SW1 while turning the key/power on. The display
should light up and show
SET SETUP on the speedometer and speed message displays.
Release the switch and SET SPEED should display, this is the start of the setup menus. Press
and release SW1 to advance through the main menus. A press and hold will enter the sub
menu. A press and hold is also used to save the setting and jump to the next option, or exit a
menu when DONE is displayed.