Dakota Digital LED Tail Lights for 1956 Chevy Car LAT-NR200 User Manual
Dakota Digital For the car
MAN#650184
INSTALLATION INSTRUCTIONS
LAT-NR200
LED Tail Lights for 1956 Chevy Car
MAN#650184
Kit Includes:
Installation:
1. Remove the two screws that are in the tail light lens, and
remove the lens.
2. Remove the light bulb.
3. Push and twist to remove the plastic bulb socket from the back side of the
housing.
4. Now is a good time to clean the lens and housing. If lenses are in bad shape a new set is
recommended.
5. Remove the nut, washer, and aluminum spacer from the back of the
new LED assembly, noting how it is assembled for re-assembly.
Gently pull the wires through the aluminum spacer so the insulation is
not damaged.
6. Insert the new LED assembly, wires first, through the hole where the
original bulb and plastic socket were. Use caution when feeding the
wires through to avoid damaging the wire insulation.