Delta 46-715 - Manual (Page 6)

6
ASSEMBLY INSTRUCTIONS
ASSEMBLING STAND
Fig. 3
1. Attach the two long tie bars (A) Fig. 3 (with flanges up)
to the center of each stand leg (B) by using eight carriage
bolts through the legs and tie bars, secured by flat wash-
ers, lockwashers, and hex nuts. NOTE: Do not completely
tighten hardware at this time.
2. Attach two short tie bars (C) Fig. 3 (with flanges up), to
each leg (B), using eight carriage bolts through the legs and
tie bars, secured by flat washers, lockwashers, and hex
nuts.
3. Attach the two stand tops (D) Fig. 3 to the inside of the
top of stand legs (B) using twelve carriage bolts through the
leg, then through the stand top. Secure with flat washers,
lockwashers, and hex nuts.
Fig. 5
A
ATTACHING LATHE BED TO STAND
The 46-715 lathe comes attached to plyboard. To attach the lathe bed to the stand:
1. Remove the security bars (A) Fig. 4 that are attached to both ends of the lathe bed by removing the two screws (B) Fig.
4 that secure it.
2. CAUTION: The headstock is very heavy. Have someone help remove it from the lathe bed.
3. Loosen the lock handle (A) Fig. 5 and slide the headstock off the end of the lathe bed.
4. Loosen the lock handle (A) Fig. 6 and slide the tool rest off the end of the lathe bed.
5. Loosen the lock handle (A) Fig. 7 and slide the tailstock off the end of the lathe bed.
6. Remove the two bolts (one is shown at (A) Fig. 8) to free the lathe bed from the plyboard.
B
B
C
C
D
Fig. 4
A
B
Fig. 6
Fig. 7 Fig. 8
A A
A
A