Foreword, Extension cords, Unpacking and cleaning – Delta 46-715 User Manual
Page 5: Carton contents
5
EXTENSION CORDS
Fig. C
Use proper extension cords. Make sure your extension
cord is in good condition and is a 3-wire extension cord
which has a 3-prong grounding type plug and matching
receptacle which will accept the tool’s plug. When using
an extension cord, be sure to use one heavy enough to
carry the current of the tool. An undersized cord will
cause a drop in line voltage, resulting in loss of power
and overheating. Fig. C, shows the correct gauge to use
depending on the cord length. If in doubt, use the next
heavier gauge. The smaller the gauge number, the
heavier the cord.
UNPACKING AND CLEANING
Carefully unpack the tool and all loose items from the shipping container(s). Remove the protective coating from all
unpainted surfaces. This coating may be removed with a soft cloth moistened with kerosene (do not use acetone,
gasoline or lacquer thinner for this purpose). After cleaning, cover the unpainted surfaces with a good quality paste wax.
WARNING: FOR YOUR OWN SAFETY, DO NOT CONNECT THE TOOL TO THE POWER SOURCE UNTIL THE
TOOL IS COMPLETELY ASSEMBLED, AND YOU READ AND UNDERSTAND THE ENTIRE OWNER’S MANUAL.
Fig. 1
CARTON CONTENTS
FOREWORD
The Delta 46-715 14" adjustable speed wood lathe is a
big capacity lathe, designed for industry, commercial
shops, and schools.
Fig. 2
MINIMUM GAUGE EXTENSION CORD
RECOMMENDED SIZES FOR USE WITH STATIONARY ELECTRIC TOOLS
Ampere
Total Length
Gauge of
Rating
Volts
of Cord in Feet
Extension Cord
0-6
120
up to 25
18 AWG
0-6
120
25-50
16 AWG
0-6
120
50-100
16 AWG
0-6
120
100-150
14 AWG
6-10
120
up to 25
18 AWG
6-10
120
25-50
16 AWG
6-10
120
50-100
14 AWG
6-10
120
100-150
12 AWG
10-12
120
up to 25
16 AWG
10-12
120
25-50
16 AWG
10-12
120
50-100
14 AWG
10-12
120
100-150
12 AWG
12-16
120
up to 25
14 AWG
12-16
120
25-50
12 AWG
12-16
120
GREATER THAN 50 FEET NOT RECOMMENDED
1.
Headstock Assembly
2.
Tool Rest Assembly
3.
Tailstock Assembly
4.
Lathe Bed
5.
Leg (4)
6.
Short Tie Bar (2)
7.
Stand Top
8.
Long Tie Bar (2)
1.
Knockout Bar
2.
Spindle Wrench
3.
Live Center
4.
Drive Center
5.
M8 x 35mm Hex Head Screws (8)
6.
M8 x 16mm Carriage Bolts (24)
7.
Flat Washers (32)
8.
Lockwashers (32)
9.
Nuts (32)
1
2
3
4
5
6
7
8
1
2
4
3
5
8
7
9
6