Delta 46-715 - Manual (Page 19)

19 19 19
MAINTENANCE
Fig. 71
REPLACING DRIVE BELT
1. Remove the four screws (A) Fig. 71 (three of which
are shown) to take the back off of the headstock.
2. Use a #5 Allen wrench to remove the three screws
(A) Fig. 72. Slide the spindle handle out. Pull the spindle
lock to the out position (see Fig. 24A).
Fig. 72
3. Remove the belt (A) Fig. 73 from the pulley (B).
NOTE: When pulling the belt out or replacing the belt,
pull the spindle lock handle (B) Fig. 72 out to its fullest
position to give more room (C) Fig. 73 for belt removal or
replacement.
Replace new belt by using these instructions in reverse
order.
Fig. 73
A
A
A
A
B
A
B
C