DR Power 3-Point Hitch Top-Discharge User Manual
Page 7

7
MAINTENANCE AND STORAGE
• Keep machine, attachments and accessories in safe working condition.
• Check hardware at frequent intervals for proper tightness. Never operate your chipper in poor mechanical
condition or when in need of repair. Be sure all safety guards and shields are in proper position. These safety
devices are for your protection.
• Always refer to the operator’s manual for important details if the machine is to be stored for an extended
period.
• Follow the manufacturer’s recommendations for safe loading, unloading and storage of machine.
• If it is necessary for any reason to unclog the feed intake or discharge openings or to inspect or repair the
machine where a moving part can come in contact with your body or clothing, shut the tractor off and allow all
moving parts to come to a complete stop before attempting to unclog, inspect or repair.
• Check the knife mounting screws at frequent intervals for proper tightness. Also visually inspect the knife for
wear or damage. Replace the knife with parts that meet original equipment specifications.
• Knives should be checked for sharpness and the bolts attaching them to the flywheel for tightness every 8-10
hours of operation.
• Replace the nylock nuts securing the knife every time you replace the knife.
• Check the gap between the knife and wear plate every time you sharpen or replace the knife, or every 8-10
hours of operation.
• Never tamper with safety devices. Check their proper operation regularly.
• Inspect the belt each time you use the unit. Look for damage, worn areas or tears. Do not use the unit if this
condition exists.
• This machine is designed to operate at 540 RPM only. Do not operate at a faster speed that may cause
serious injury to the operator or bystanders and could cause damage to the machine that will not be covered
under warranty.