DNF Controls ST304-DSR1K-HL - Manual (Page 20)

1 1 6 6 o o f f 2 2 7 7 ST304-DSR1K, Slow Motion Controller
B. RECEIVE CUE LIST FUNCTION
The RECEIVE CUE LIST function allows you to receive a list of Cue
Points from a PC or from another ST300. Transfer to a PC requires
OpSuite 3.0 software, which runs on a Windows-based computer.
Contact DNF Controls for more information.
1) To Receive Cue Points From Another ST300
a) Connect the VTR4 connector on the back of the ST300 from the
VTR4 connector of the transmitting ST300 using RS422 9-pin cable
with TX and RX lines crossed. (A “Turnaround” Cable)
b) Press [MENU].
c) Scroll the Wheel until “Receive CUE List? YES=Enter, Exit=ESC” is
displayed.
d) Press [ENTER] to start receiving.
e) The Display shows “Waiting to receive” on the first line.
f) When the Transmitter is ready, transfer starts automatically. The
Display now shows “Receiving Cuelist.”
g) After the transfer is over the display shows “Done-Success! Press
any key…”
h) Press any key. The display shows “Receive Cuelist?” message.
i) Press [ESC] to exit the MENU mode.
2) To Receive Cue Points from the PC
a) Connect the VTR4 connector on the back of the ST300 to one of
the COM ports on the PC using RS422 to RS232 adapter.
b) Press [MENU].
c) Scroll the Wheel until “Receive CUE List? YES=Enter, Exit=ESC” is
displayed.
d) Press [ENTER] to start receiving.
e) The Display shows “Waiting to receive” on the first line.
f) When the Transmitter is ready, transfer starts automatically. The
Display now shows “Receiving Cuelist.”
g) After the transfer is over the display shows “Done-Success! Press
any key…”
h) Press any key. The display shows “Receive Cuelist?” message.
i) Press [ESC] to exit the MENU mode.