DNF Controls ST304-DSR1K-HL - Manual (Page 19)

ST304-DSR1K, Slow Motion Controller 1 1 5 5 o o f f 2 2 7 7
Advanced Features . . .
6. TRANSFER CUELIST
NOTE: Only the CUE points are transferred. The HIGHLIGHT playlists are not
saved and can not be restored.
A. TRANSMIT CUE LIST FUNCTION
The TRANSMIT CUE LIST function allows you to transmit your list of Cue
Points to a PC, using the provided utility software on the PC, or to
another ST300. Transfer to a PC requires OpSuite 3.0 software, which
runs on a Windows-based computer. Contact DNF Controls for more
information.
1) To Transmit Cue Points to Another ST300
a) Connect the VTR4 connector on the rear of the ST300 to the VTR4
connector of the receiving ST300 using an RS422 9-pin cable with
TX and RX lines crossed. (A “turnaround” cable.)
b) Press [MENU].
c) Scroll the Wheel until “Transmit CUE list? YES=Enter, Exit=ESC” is
displayed.
d) Press [ENTER] to start transmitting. The Display shows “Waiting
to transmit” on the first line.
e) When the Receiver is ready, transfer starts automatically. The
Display now shows “Transmitting Cuelist.”
f) After the transfer is over, the display shows “Transfer is over” for
one second and then shows “Waiting to transmit” again.
g) Connect another ST300 to transmit the list again.
OR
h) Press [ESC] twice to exit the MENU mode.
2) To Transmit Cue Points to a PC
a) Connect the VTR4 connector on the back of the ST300 to one of
the COM ports on the PC using a RS422 to RS232 adapter.
b) Press [MENU].
c) Scroll the Wheel until “Transmit CUE list? YES=Enter, Exit=ESC” is
displayed.
d) Press [ENTER] to start transmitting. The Display shows “Waiting
to transmit” on the first line.
e) When the Receiver is ready, transfer starts automatically. The
Display now shows “Transmitting Cuelist.”
f) After the transfer is over, the display shows “Transfer is over” for
one second and then shows “Waiting to transmit” again.
g) Press [ESC] twice to exit the MENU mode.