DNF Controls ST304-SRP-PBIO - Manual (Page 22)

20 ST304-S-SRP-PBIO & ST304S-SRP-T-PBIO, Slow Motion Controller
SLOMO [SLOMO] Press SLOMO to slo-mo the VTR. Turn the Wheel or move
the T-Bar to change the play speed.
Press SLOMO to STILL frame OR press any transport key to
exit.
SLO-MO
SPEED PRESET
[SHIFT] + [SLOMO] For WHEEL ONLY - to preset the slo-mo speed. Turn the
Wheel to select desired speed.
Press [ESC] OR any transport key to exit.
STOP [STOP] Press once to STILL frame VTR.
Press again to put VTR into STOP mode.
TIME MODE
SELECT
[TIME MODE] Press to toggle between Timecode (TC), VITC (VT) or Tape
Timer (TM) display modes.
GO TO
IN POINT
[RECUE] Press to search to currently set IN point.
MARK
IN POINT
[IN] Save current time as IN point.
Per SETUP MENU, the Cue Point Location will advance to
the next Cue Point location or remain the same.
MARK
OUT POINT
[OUT] Save current time as OUT point.
Note: OUT point is always saved in the current Cue Point.
TIME PRESET
(Generator
Preset)
[SHIFT] +
[TIME MODE] Press to enter Time Preset.
Press [ENTER] to load Time Generator with 00:00:00:00.
OR enter the time desired via the numeric keypad and press
[ENTER] to load that time.
OR press [ESC] to exit without saving.