DNF Controls ST304-SRP-PBIO - Manual (Page 12)

10 ST304-S-SRP-PBIO & ST304S-SRP-T-PBIO, Slow Motion Controller
j. RECORD MODE SELECTION
1) Press [MENU]. The MENU indicator will turn on.
2)
Turn the Wheel until “REC” is viewed on the top line of the display. The
current Record mode is shown.
3) Press
[MENU] to select:
Record Lockout, Assemble, Crash or Insert Record mode.
4) INSERT
ONLY - Press the desired Softkey to toggle Video, Audio1, Audio2,
Audio3 or Audio4 record on/off.
The Softkeys are located just below the display.
Follow the line graphic from the bottom of the display to the Softkey.
5) Press [ESC] to exit the MENU. The MENU indicator will turn off.
OR
Turn the Wheel for other setup options.
7. SIMULTANEOUS RECORD/PLAYBACK FUNCTIONS
a. CREATE A NEW CLIP
Prior to the start of the recording you must open a file on the DDR record channel. Each
file (channel) must be given a unique name. Once the channels have been put into
record, the clips need to be loaded on the corresponding play channel of the DDR.
1) Create a clip on the video server using local controls on the server unit. This
opens a file ready for recording.
Do not start the record process at this time. Use the record function on
the ST300 when you are ready to actually start recording.
2) CREATE A CLIP ON EACH RECORD CHANNEL OF THE VIDEO
SERVER
b. START RECORD
1) Press [SHIFT] + [REC] on VTR1 to start recording on Record channel
connected to VTR3 connector of the ST300.
2)
The Record LED turns ON.
3) Press
[SHIFT] + [REC] on VTR2 to start recording on Record channel VTR4
connector of the ST300.
4)
The Record LED turns ON.
c. STOP RECORD
1) Press [SHIFT] + [STOP] on VTR1 to stop recording on Record channel
connected to VTR3 connector of the ST300.
2)
The Record LED turns OFF.