DNF Controls ST304-SRP-PBIO - Manual (Page 11)

9 ST304-S-SRP-PBIO & ST304S-SRP-T-PBIO, Slow Motion Controller
f. SAVE A CUE POINT (AUTO MARK ON)
If AUTO MARK MODE is ON, when [IN] or [MARK] key is pressed, the OUT point is
automatically calculated as IN + SEG duration, then saved in the cuepoint.
When OUT key is pressed, the IN is automatically calculated as OUT – SEG duration,
and saved in the cuepoint.
AUTO MARK allows one-key marking of segments by automatically calculating the
OUT point. You can turn it ON/OFF in the Setup Menu.
g. GOTO/PREROLL TO A CUE POINT
1) Select the desired Cue Point. The Cue number and its contents are shown on the
bottom line of the display.
2)
Press [GOTO] to search to the IN point saved in the Cue Point.
After cuepoint is recalled, the IN and OUT LEDs are ON.
h. PLAYING SEGMENTS
1) Select VTR channel to PLAY.
2) Press [PLAY] key.
The Player will start playing and it will stop when the time code reaches the
OUT point.
The third line of the display shows “Playing Segment…”
If the Player is positioned after the OUT point, the playout will continue until
[STOP] is pressed.
3) Press [PLAY] + [SHIFT] to disregard the OUT point and continuously play
until [STOP] is pressed.
4)
In Variplay (SloMo) mode, the Playback will stop once the time code reaches
the OUT point.
i. GOTO/PREROLL TO A MANUALLY ENTERED TIME
1) Press
[ENTER TIME] to use the numeric keypad.
Manually enter a time on the numeric keypad.
2) Press [GOTO] OR [RECUE] to search to the entered time.
OR
Press [ESC] to exit without searching.
The ENTER TIME indicator will turn off.