DNF Controls ST304-SRP-PBIO - Manual (Page 14)

12 ST304-S-SRP-PBIO & ST304S-SRP-T-PBIO, Slow Motion Controller
8. PRODUCTION SWITCHER FUNCTIONS
a. TRIGGERS
The operator fires a trigger using either the Timeline or Run function on the production switcher.
The ST304 puts the DSR-DR1000 into the following modes based upon the trigger value:
GRASS VALLEY GROUP VALUES
Trigger
Value Mode
0 Play
1 Recue to beginning of clip
2 Slow-mo using ST300 Wheel Preset or T-Bar Speed
3 Reverse Play
4 Still Frame
5 Loop
6 Record
7 or greater Play
SONY VALUES
Trigger Value Mode
0 Recue to the IN point
1 Play (If OUT point set – play segment).
2 Slo-mo using ST300 Wheel Preset or T-Bar Speed
3 Reverse Play
4 Still Frame
5 Play
6 Record
7 or greater Play
b. LEARN
If the IN and OUT points exists (IN and OUT LEDs are on), the ST304 saves the current
IN and OUT points into the specified register number for the channel with the specified
PBIO address.
If no IN or OUT points exists (IN and OUT LEDs are off), the ST304 saves the current
time into the IN Point of the specified register number for the channel with the specified
PBIO address.
c. RECALL
When Recall command is received, the channel will cue to the IN point of the specified
register number for the specified PBIO address.