DNF Controls ST304-SRP-PBIO - Manual (Page 19)

17 ST304-S-SRP-PBIO & ST304S-SRP-T-PBIO, Slow Motion Controller
ST300 SETUP
Press Softkey beneath ClearCues to clear all Cue Points to 00:00:00:00.
Press Softkey [YES] when asked “Are You Sure?”
Press Softkey beneath SetDefault to set ST300 to default settings.
Press Softkey [YES] when asked “Are You Sure?”
DISPLAY
SOFTWARE
VERSION
The version number for the currently installed software is displayed.
VIDEO
STANDARD
Press Softkey to select NTSC, PAL, or 24P video standard, depending on the standard
you’re using.
INPUT VIDEO
DELAY
Input Video Delay specifies the time interval between video recorded on the Recorder part
of the DdR being available for playback.
This parameter is used in GO TO LIVE function.
The default value is 5 seconds.
REFERENCE
VIDEO
Press softkey to Enable/Disable Reference Video.
MARK-Q Press Softkey to:
Enable ADVANCE to next Cue Point, when [MARK] is pressed.
OR
Maintain CURRENT Cue Point when [MARK] is pressed.
DROP
FRAME
Press Softkey to select DROP FRAME ON or OFF.
Used to preset the VTR’s Timecode Generator.
SEG DURATION Enter SEG duration that will be used to calculate IN (OUT) point.
AUTO MARK Press softkey to turn AUTO MARK ON/OFF.
AUTO MARK allows one-key marking of segments.
TRANSMIT
CUELIST
Transmits Cuelist to another ST300 or to a PC.
RECEIVE
CUELIST
Receives Cuelist from another ST300 or a PC.
PBIO ADDRESS Press VTR key to assign PBIO address.
Display shows:
Enter address number desired on numeric keypad. Repeat for all VTRs assigned.
ST300 SETUP
Clear Cues SetDefault
PBIO Address = 00
Enter 00-23