DNF Controls ST200-S-RCP - Manual (Page 9)

ST200-S/RCP 9
Reference . . .
6. SPECIFICATIONS
a. ST200-S/RCP
Front Panel
6 Status LEDs
Record, Play, Stop, Rewind, FFwd, Jog, Shift
1 Power LED
3 Direction LEDs
Indicates direction of Jog Shuttle
Switches Record, Play, Stop, Rewind, Fast Forward, Jog, Shift
Display 2-Line LCD, back lit with adjustable contrast
Jog/Shuttle Wheel
Size 8 ½” x 5 ½” x 2 ½”
Weight 4 lbs.
Rear Panel
DIP Switches
3-6, Binary switches for unit ID
LCD Contrast adjust
Reset
Ground Terminal
RS422 Serial Out
9-Pin D-type connector, female (DB9-F)
Port Expander 9-Pin D-type connector, female (DB9-F)
Power: 9-Pin D-type connector, male (DB9M)
5 volt D.C., 1 A. 90-265 VAC,
50/60 Hz converter supplied
GPI 15-Pin D-type connector, female (DB15F)
Switch Input: SPST contact closure, momentary
Status Output: Open collector, sink 50mA.
External Interface Connector (GPI) DB15F
PIN FUNCTION NOTE
1 +5v DC
2 SHIFT Switch Active Low
3 Record Tally Active Low, Open-Collector
4 Play Tally Active Low, Open-Collector
5 Stop/Still Tally Active Low, Open-Collector
6 Rewind/ Reverse Tally Active Low, Open-Collector
7 Fast Forward/ Forward Tally Active Low, Open-Collector
8 Jog Tally Active Low, Open-Collector
9 Command Common
10 Record Command Active Low
11 Play Command Active Low
12 Stop Command Active Low
13 Rewind Command Active Low
14 Fast Forward Command Active Low
15 Jog/Shuttle Select Command Active Low
NOTE: There are no internal current limiting resistors for the open-collector Tally
Outputs. Limit each Tally Output current to 40ma.