DNF Controls ST200-S-RCP - Manual (Page 8)

ST200-S/RCP 8
e. RESTORE PRESET
1) Press [PRESET]. The PRESET indicator will turn on.
The first line of the display will show “Recall Preset 1.”
2) Turn the Wheel to select preset number 1-8.
3) Press [TAKE] to restore selected preset.
OR
Press
[ESC] to exit without restoring.
5. CONTROLLER FUNCTIONS
Select the desired transport function by pressing the appropriate switch on the front of the SLOW
MOTION CONTROLLER.
The Real-Time Status Indicators will light to indicate the VTR's current tape transport mode.
For example - Pressing [PLAY] will put the VTR into the PLAY mode. The PLAY Status
Indicator will turn on when the VTR is in PLAY mode.
NOTE: The VTR will not go into Record mode if "Record Inhibit" is enabled on the VTR or tape
cassette.
Loss of serial communication with the VTR is indicated by ALL bottom row status LEDs turned
ON.
The top line of the display will show “VTR COMM ERROR.”
Check all cabling and connections between the VTR and the ST200-S/RCP.
Selecting LOCAL control on the VTR's front panel will turn OFF all bottom row status LEDs.
RECORD MODE SELECTION
Four (4) Record modes are available: Crash Record (Full Record), Assemble Record, Insert
Record and Record Lockout.
To change RECORD MODE:
Press [SHIFT] + [RECORD].
Then, press [RECORD] to toggle through Record Lockout, Assemble, Crash or Insert
Record modes.