DNF Controls ST200-S-RCP - Manual (Page 7)

ST200-S/RCP 7
4. OPERATION
a. MAKE A ROUTE
Press [FROM]. The FROM indicator will turn on.
The left side of the display shows the currently selected FROM connector (PORT1-32).
Turn the Wheel until the desired FROM point is displayed.
Press [TO]. The TO indicator will turn on. The right side of the display shows the
currently selected TO connector (PORT1-32). Turn the Wheel until the desired TO point
is displayed.
Press [TAKE] to route the FROM input to the TO output.
NOTE: No Route is made until [TAKE] is pressed.
b. VIEW THE ROUTES
1) Press [VIEW]. The VIEW indicator will turn on.
2) Turn the Wheel to scroll through all ports that are displayed on the first line of
the display.
3) The second line of the display will show the port(s) connected to the selected
port.
c. DISCONNECT ROUTE
Press [FROM].
Turn the Wheel until OFF is displayed.
Press [TO].
Find the destination that you wish to turn off.
Press [TAKE] to turn off the route.
d. SAVE PRESET
1) Press [SHIFT] + [PRESET]. The PRESET indicator will turn on.
The first line of the display will show “Save Preset 1.”
2) Turn the Wheel to select preset number 1-8.
3) Press [TAKE] to save current configuration into the selected preset.
OR
Press
[ESC] to exit without saving.