DNF Controls ST200-S-RCP - Manual (Page 6)

ST200-S/RCP 6
b. SW32PS PORT SWITCHER
1)
Plug one end of a 9-pin cable into a VTR/DDR/Video Server. Plug the other
end into any of the 32 connectors on the back of the switcher.
2)
Connect DB9F side of supplied power supply into the connector labeled
“Power.” Then connect the IEC to Edison cable to the power supply. Connect
the power cable to a 90 VAC to 240 VAC source.
Caution: Do Not Hot Plug the Power Supply (DB9F) !
3) Press
[MENU] on the SW32PS front panel to enter MENU mode. Scroll the
Wheel to the menu option “External Devices.” Select the number that matches
the number of ST200-S/RCP controllers that will be connected.
Installation is complete.
CONNECTION DIAGRAM