DNF Controls DMAT-O-42 - Manual (Page 6)

Page 4 of 23 DMAT-O-42 Sports Controller, Odetics Protocol
III. SYSTEM INSTALLATION
Refer to the Connection Diagram.
A. DMAT-O Sports Controller
1. Plug one end of a standard 9-conductor, RS422 serial cable into the
VTR1 connector on the rear of DMAT-O. Plug the other end of the
cable into the 9-pin RS422 connector on the Video Server
associated with Playback Channel 1.
2. Plug one end of a standard 9-conductor, RS422 serial cable into the
VTR2 connector on the rear of DMAT-O. Plug the other end of the
cable into the 9-pin RS422 connector on the Video Server
associated with Playback Channel 2.
3. Connect the supplied POWER SUPPLY, APX#4108, into the POWER
connector on the rear of DMAT-O. Plug the Power Supply into an
outlet, 90 VAC - 240 VAC.
4. Connect unbalanced “Time Of Day” time source (LTC) to the LTC
Input connector on the rear of DMAT-O, using a BNC cable
5. Connect Black Burst Signal to the ref. Video Connector on the back
of the DMAT-O using a BNC cable.
B. Video Server Setup
Select ODETICS Broadcast communications protocol on the VIDEO SERVER
playback channels to be controlled.
For PROFILE Video Server only (if planning to use in Drop Frame):
1. On VDRPanel, use the mouse to select the playback channel
assigned to P1 (VTR1) on DMAT-O.
2. Select OPTIONS pull down menu.
3. Select DROP FRAME.
4. On VDRPanel, use the mouse to select the playback channel
assigned to P2 (VTR2) on DMAT-O.
5. Select OPTIONS pull down menu.
6. Select DROP FRAME.
7. Connect the camera outputs/source video to the record channels
(up to 4)
8. Assign each record channel a unique name (REC 1, REC 2, REC 3,
REC 4).