DNF Controls DMAT-O-42 - Manual (Page 12)

Page 10 of 23 DMAT-O-42 Sports Controller, Odetics Protocol
VI. GANG CHANNELS
Press [GANG] key. Gang LED turns on. P1 and P2 channels are ganged for
playback.
Set “Gang Record” option (see SETUP MENU section) in order to select which
camera angles will be used to create clips in Gang Mode.
NOTE: You must have Reference Video connected in order to gang Channels.
VII. CLIP NUMBERING
Clip numbers range from 1000 to 1399, 2000 to 2399, 3000 to 3399, and
4000 to 4399.
The 1 st digit refers to the Input from which the clip was created. All clips
created from CAM1 will be saved in clip numbers 1000 to 1399.
Saving Clips
After marking an In point and Out point, then press the Save Key. The
created clip will be saved at the next available clip number, in the number
range corresponding to the input currently selected on the playback channel.
If a 4-digit number is entered prior to pressing the Save Clip key, then the clip
will be saved at the entered clip number.
If a 3-digit number is entered prior to pressing the Save Clip key, then the clip
will be saved at the entered clip number in the number range corresponding to
the input currently assigned to the playback channel.
Recalling Clips
If a 4-digit number is entered prior to pressing the Recall Clip key, the entered
clip number will be recalled.
If a 3-digit number is entered prior to pressing the Recall Clip key, the
playback channels currently assigned input will determine the number range
from which the clip will be recalled.
For example:
Assign CAM3 to playback channel 1.
Enter ‘123’ then press the Recall Clip key.
Clip number 3123 will be recalled.