DNF Controls DMAT-O-22 - Manual (Page 8)

Page 4 of 21 DMAT-O-22 Sports Controller, Odetics Protocol
II. SYSTEM INSTALLATION
Refer to the Connection Diagram.
A. DMAT-O-22 Sports Controller
1. Using standard 9-conductor (pin to pin), RS422 serial cable, follow
the connection diagram to connect the controller to the server.
Identify your chassis by comparing the "C" number on the serial
number tag to the illustration number.
2. Connect Black Burst Signal to the Ref. Video connector on the rear
of DMAT-O-22 using a BNC cable.
3. Connect the supplied POWER SUPPLY, APX#4108, into the POWER
connector on the rear of DMAT-O-22. Plug the Power Supply into
an outlet, 90 VAC - 240 VAC.
B. Video Server Setup
Select ODETICS Broadcast communications protocol on the VIDEO SERVER
playback channels to be controlled.
For PROFILE Video Server only:
On VDRPanel, use the mouse to select the playback channel assigned
to P1 (VTR1) on DMAT-O.
Select OPTIONS pull down menu.
Select DROP FRAME.
On VDRPanel, use the mouse to select the playback channel assigned
to P2 (VTR2) on DMAT-O.
Select OPTIONS pull down menu.
Select DROP FRAME.
NOTE – All record and playback clips must be located in the “Default”
directory.
Installation is complete.