DNF Controls 4040CL-EVS-PBIO - Manual (Page 9)

4040CL-EVS-PBIO, 300 Clip Fast Access System, EVS DDRs Page 9 of 26
6. LEARN A CLIP OR CLIP COMBINATION
a. LEARN ON THE PRODUCTION SWITCHER
1) On ST400, Load a clip(s) on the desired VTR(s). (See “LOAD A CLIP,”
Section 4.
2) Select and enable the Peripheral Device Addresses for the ST400.
3) Do a LEARN to the desired REGISTER.
The ST400 will: LEARN (save) the VTR number, loaded CLIP ID and current
IN & OUT time into the REGISTER number in the ST400.
b. LEARN ON THE ST400
1)
Press VTR [1], [2], [3], [4], [5] or [6] to select the channel to learn.
2)
Load a clip on the selected channel. See section LOAD A CLIP.
3)
Use the transport functions to view the clip.
Press [IN] to mark an IN point. The IN LED will turn on.
On recall, the clip will cue to the IN time, not the beginning of the clip.
Optional- Press [OUT] to mark an OUT point. The OUT LED will turn on.
On recall, the clip will play to the OUT point then stop.
To delete an IN or OUT point, press and hold [DEL], then press [IN] or [OUT].
The IN/OUT LED will turn off.
If no IN point is marked, the current location of the clip will be learned as the IN
point.
4)
For GANGs, repeat steps a. and b. for each channel.
Then, press the [GANG] softkey.
Press VTR [1], [2], [3], [4], [5] or [6] to add it to the GANG. The VTR led will
turn on.
Press the VTR key again to remove it from the gang. The VTR led will turn off.
Press
[ESC] to exit GANG mode. The LEDs of all GANGed VTRs will turn on.
5)
Select the desired Cue Point by pressing [NEXT CUE], [LAST CUE] or by
manually entering the Cue Point using the numeric keypad, followed by
[ENTER].
The selected Cue Point number is shown on the bottom part of the display.
6)
Press [SHIFT] + [LEARN] to initiate the LEARN.
The display will show: “Select VTRs to learn:--------”