DNF Controls 4040CL-EVS-PBIO - Manual (Page 12)

4040CL-EVS-PBIO, 300 Clip Fast Access System, EVS DDRs Page 12 of 26
12. PRODUCTION SWITCHER PBIO TRIGGER VALUES
The Production Switcher outputs a Peripheral Bus trigger at specific Timeline key frames, as
programmed by the operator. The 2044CL performs a specific function for each trigger value:
GRASS VALLEY GROUP Production Switcher
Trigger Value Mode
0 Play (If OUT point is specified, stop at OUT.)
1 Recue to beginning of clip
2 Slo-mo using ST400 Preset Speed
3 Reverse Play
4 Still Frame
5
6 Record
7 or greater Play
SONY Production Switcher
Trigger Value Mode
0 Recue to beginning of clip Play
1 Play (If OUT point is specified, stop at OUT.)
2 Slo-mo using ST400 Preset Speed
3 Reverse Play
4 Still Frame
5
6 Record
7 or greater
Play
To control more than one VTR, enable the Peripheral Device Address for each VTR. The Trigger
value will be sent to the enabled devices.
OR
GANG the required VTRs on the ST400. See “FUNCTION TABLE,” Section 16, for GANG
instructions. Enable the Peripheral Device Address for one of the GANGed VTRs. The Trigger
will be sent to the enabled VTR. The other VTRs in the GANG will perform the same action.