DNF Controls 4040CL-EVS-PBIO - Manual (Page 11)

4040CL-EVS-PBIO, 300 Clip Fast Access System, EVS DDRs Page 11 of 26
9. CLEAR CUE POINTS
a. Select the cue point to be cleared using [NEXT CUE], [LAST CUE], or manually
entering the cue point number.
b. Press
[SHIFT] + [LEARN].
The CLEAR softkey will be displayed on the bottom of the display.
c.
Press the [CLEAR] softkey to clear the cue point.
The cue point will be cleared and the display will return to the normal screen.
OR
Press [ESC] to escape without clearing.
10. PLAY CLIP SEGMENT
a. Set an IN Point and OUT Point.
Jog/Shuttle to the desired IN point. Press [IN].
Jog/Shuttle to the desired OUT point. Press [OUT].
OR
Press [SHIFT] + [IN]. Manually enter the IN time on the numeric keypad. Press
[ENTER].
Press [SHIFT] +[OUT]. Manually enter the OUT time on the numeric keypad. Press
[ENTER].
b.
Press [RECUE]. The clip will cue to the IN point.
c.
Press [PLAY].
The clip will play from its current time to the OUT point, then stop.
11. PBIO ENABLE/DISABLE
On the ST400 press the [PBIO] softkey to enable or disable PBIO. When disabled, the ST400 will
ignore all Pbus commands. When enabled, the ST400 will respond to all Pbus commands.
When enabled and Pbus commands are received, the softkey’s LED will flash.