DNF Controls 4040CL-EVS-PBIO - Manual (Page 6)

4040CL-EVS-PBIO, 300 Clip Fast Access System, EVS DDRs Page 6 of 26
3. SYSTEM INSTALLATION
a. ST400-S/SM, VTR/DDR CONTROLLER
1) Plug one end of a 9-conductor, RS422 serial cable into the VTR1 (2, 3, 4, 5 or 6)
connector on the rear of the ST400. Plug the other end of the cable into the 9-pin
REMOTE connector on the Video Server.
2)
Connect the supplied POWER SUPPLY, APX#4108, into the POWER connector
on the rear of the ST400. Plug the Power Supply into an outlet, 90 VAC - 240
VAC.
3)
Check SETUP MENU prior to using the ST400 to confirm proper Record mode
and other User settable modes.