DNF Controls 4000CL-L Vs.3.0 - Manual (Page 17)

17 4000CL-L, Vs.3.0, 400 Clip Fast Access System, Louth Protocol
14. FUNCTION TABLE
Function Key Press Description
ENTER
RECORD
LENGTH
[SHIFT] +
[RECORD] Enter the desired record length using the numeric keypad.
Press [ENTER] to accept.
FFWD
[FFWD] Press and HOLD to shuttle. Release key to stop. Set WIND Speed in MENU.
GANG
[SHIFT] + [VTR #1]
OR
[SHIFT] + [VTR #2]
OR
[SHIFT] + [VTR #3]
OR
[SHIFT] + [VTR #4]
Individually press the VTR keys to be included in the gang; the LED above the
key will turn on. Press the VTR key again to remove from gang; the LED
above the key will turn off. Press [ESC] to exit.
The VTR LEDs that are on show the gang.
The flashing LED shows which VTR is currently selected.
GO TO
ENTERED
TIME
[SHIFT] + [RECUE] Enter the desired recue time using the numeric keypad.
Press [ENTER] or [RECUE] to reload the currently loaded clip at the entered
time.
JOG [JOG] Select JOG mode and enable Wheel.
LAST CUE
[LAST CUE] Step to the previous Cue Point Location.
NEXT CUE [NEXT CUE] Step to the next Cue Point Location.
RECORD
[REC] Places VTR into the Record mode selected by RECORD MODE in the SETUP
MENU. Press [RECORD] or [RECORD] + [PLAY].
REWIND [RWD] Press and HOLD to shuttle. Release key to stop. Set WIND Speed in MENU.
SHUTTLE [SHUTTLE] Select SHUTTLE mode and enable Wheel.
SLOMO [SLOMO] Press [SLOMO] to slo-mo the VTR. Turn the Wheel to change the play speed.
Press [SLOMO] to STILL the frame.
OR
Press any transport key to exit SLOMO.
SLO-MO
SPEED
PRESET [SHIFT] + [SLOMO] For WHEEL ONLY: Press [SHIFT] + [SLOMO] to preset the slo-mo speed.
Turn the Wheel to select desired speed.
Press [ESC] or any transport key to exit.
STOP [STOP] Press once to STILL frame VTR.
TIME MODE
SELECT [TIME MODE] Press to toggle between:
Remaining time (RT)
OR Elapsed time (ET).