DNF Controls 4000CL-LPH - Manual (Page 7)

7 7 4000CL-LPH, 400 Clip Fast Access System, Louth Phillips Protocol
6. LOOP A CLIP
NOTE:
O
NLY clips loaded from the SHOTLIST can be looped.
Any clip in the SHOTLIST can be played as a continuous loop
OR
Once from the beginning to the end of the clip.
a. SET CLIP PLAY MODE: CONTINUOUS LOOP OR
NORMAL
On the ST300
1) Press
[CLIPLIST]. The LED above CLIPLIST comes on.
2)
Select the desired SHOTLIST location by pressing [NEXT CUE], [LAST
CUE] or manually entering the 1-, 2- or 3-digit location number.
3) Press
[PLAY] to set the play mode of the saved CLIP ID in the currently
displayed SHOTLIST location shown on the bottom line of the display.
4)
Select NORMAL or LOOP CLIP modes:
NORMAL will play from the beginning, to the end of the clip and stop. The
Play Mode indicator to the right of the CLIP ID will be blank.
LOOP CLIP (LC) will play from the beginning to the end of the clip, then loop
back to the beginning and repeat. The Play Mode indicator to the right of the
CLIP ID will show LC.
5) Press
[ESC] to exit CLIPLIST function at any time.
b. LOAD AND PLAY A LOOPED CLIP
On the ST300
1)
Select the desired SHOTLIST location by pressing [NEXT CUE], [LAST
CUE] or manually entering the 1-, 2- or 3-digit location number
2) Press
[LOAD] to load the desired Clip.
3) Press
[PLAY].
4)
The CLIP will continually loop until [STOP] is pressed.