DNF Controls 4000CL-LPH - Manual (Page 4)

4 4 4000CL-LPH, 400 Clip Fast Access System, Louth Phillips Protocol
3. SYSTEM INSTALLATION
ST300-S/SM, VTR/DDR CONTROLLER
Plug one end of a 9-conductor, RS422 serial cable into the 9-pin connector (VTR 1, VTR 2, VTR
3 or VTR 4) on the rear of the ST300. Plug the other end of the cable into the 9-pin remote
connector on the Video Server.
Connect the +5, +12, -12 VDC POWER SUPPLY into the POWER connector on the rear of the
ST300. Plug the Power Supply into a wall outlet, 90 VAC to 240 VAC.
The display shows “NO PRT Selected”.
Press [MENU] then rotate wheel until
On the top line the display shows “VTR1 LOUTH PORT=00”.
The bottom line shows “ENTER 1-9”.
Press the desired number on the numeric keypad.
To turn the port off, leave it at “00””.
NOTE: at least one Port must be assigned to a valid port.
4.
Rotate the wheel and repeat the above procedure for VTR 2, 3 and 4.
5. Press
[ESC] at any time to exit.
6.
Check the other options in the SETUP MENU prior to using the ST300 to confirm proper
Record mode, and other User settable modes.
Installation is complete.
Connection Diagram