DNF Controls 2034CL-MAV - Manual (Page 8)

8 8 2034CL-MAV, 300 Clip Fast Access System, for Sony MAV-555
6. LEARN
a. LEARN ON THE ST300
1)
LOAD a clip on the ST300 as described above.
2)
Set IN and OUT points if desired.
3)
Select the desired Cue Point by pressing [NEXT CUE], [LAST CUE], or by
manually entering the Cue Point using the numeric keypad.
The selected Cue Point number is shown on the bottom line of the display.
4) Press
[SHIFT] + [MARK] to initiate the LEARN.
The display will show:
5)
Press the VTR key desired: [1], [2], [3].
6) Press
[MARK] and the ST300 will: LEARN (save) the VTR Number (1,2,3),
loaded CLIP ID and current IN time to the selected Cue Point.
b. LEARN ON THE SHOTBOX
1) Press
[LEARN]. The LEARN indicator will turn on.
2)
Select the desired BANK and ShotKey.
3) Press
[LEARN] to exit at anytime.
NOTE: The [LEARN] key toggles LEARN mode on/off.
7. RECALL
a. RECALL ON THE ST300
1)
Select the desired Cue Point by pressing [NEXT CUE], [LAST CUE],
or by manually entering the Cue Point using the numeric keypad.
The selected Cue Point number is shown on the bottom line of the display.
2) Press
[LOAD] on the ST300.
b. RECALL ON THE SHOTBOX
Select the desired Cue Point by pressing the bank and the switch key.
Press VTR:
MARK-Lrn ESC-Cancel