DH Satellite 60 Heavy Duty Polar/Powered Dec - Manual (Page 2)

IMPORTANT!!
If you have purchased a 36” F/L one piece Antenna
(3.0M & 3.3M)
Follow these instructions
The following instructions pertain to the installation of the 36” F/L reflector only. If you have
purchased a 57.6” F/L reflector please disregard these instructions.
When you purchased the 36” F/L reflector with the 60” Ring Mount the following procedure is
necessary in order to conform the reflector to the mount.
When assembling the reflector to the mount, the 12 beveled washers must be installed between the
reflector and the mount tab. When you put the beveled washer in place make sure that the thick part is
oriented toward the reflector perimeter. This is very important as failure to do so will distort the reflector
causing loss of signal because the parabolic shape will be compromised.
Beveled Washer
1 ½” x 1 ½”
5/8” Hole
Back Ring
(1/4” x 6” x 60” dia.)
Ring Tab (1 of 2)
1/2” Nut
Beveled Washer
Rubber Washers
Antenna
1/2” Steel Washer
1/2” x 1 1/2” Bolt
Important for 36” F/L Antennas Only
Page 2
3.3M Discontinued After 1-1-2013