DH Satellite 1PC or 4PC 3m, 3.7m, & 3.8m 48 Polar/Fixed Mount - Manual

3.0M, 3.7M & 3.8M Antenna w/48” Polar Mount
1 PC or Sectional
INSTRUCTION MANUAL
CONGRATULATIONS on obtaining your new DH Antenna and mount. The 48” polar mount has
been designed with a 48” diameter ring to support both our one-piece and sectional DH 3M, 3.7M and 3.8M
antenna. This system is supplied with a “locking bar” for fixed satellite positions. The “locking bar” can be
replaced with a 36” actuator for polar tracking. PLEASE COMPLY WITH THE FOLLOWING
INSTRUCTIONS.
YOU MAY CONTACT US IF YOU HAVE ANY QUESTIONS AT 800/627-9443, 1-608-326-8406,
OR EMAIL [email protected]
THIS MOUNT IS DESIGNED TO BE USED WITH THE 3.0M – 36”F/L AND THE 3.7M & 3.8M –
57.6”F/L SPUN DH ANTENNA.
CAUTION!!
Sectional antennas MUST be handled
with EXTREME CARE.
PARTS LIST
48" MOUNT TO INCLUDE
1
48" BACK RING
1 5 1/2" BASE CAN
8 BACK BRACES
4 FEED STRUTS
1 FEED COLLAR (C14F OR KU4FL)
(heavy duty optional)
1 BOLT BAG TO INCLUDE ALL
HARDWARE (SEE BACK PAGE)
TOOLS Suggested for ease of Installation
2 1 1/8” wrench 1/2” or 3/8” Drive Ratchet
2 3/4” wrench Plus the additional sockets
2 9/16” wrench 3/4” socket
2 1/2” wrench 9/16” socket
2 7/16” wrench 1/2” socket
1 adjustable wrench
(open to 1 1/2”) 7/16” socket
2 alignment punches
1/8” ‐ 5/16” or 5/32” – 3/8”
ADDITIONAL TOOLS THAT MAYBE HELPFUL BUT NOT NECESSARY
Cordless drill 1 or 2 pair of Vise Grips
7/16” nut driver (locking pliers)
1/2” drill bit
12/18/2014