DFI HM920-HM86 - Manual (Page 29)

www.dfi .com Chapter 3 Hardware Installation
29
Chapter 3
Installing the COM Express Debug Card
Note:
The system board used in the following illustrations may not resemble the actual
board. These illustrations are for reference only.
1. COMe-LINK1 is the COM Express debug card designed for COM Express Compact and Basic
modules to debug and display signals and codes of COM Express modules.
COMe-LINK1 (For Compact/Basic modules)
Bottom view
Top view
COMe-DEBUG Connector
COM Express
Connectors
2. Connect the COMe-DEBUG card to COMe-LINK1 via a cable.
COMe-DEBUG COMe-LINK1
Cable
COMe-DEBUG
COM Express
Connectors
COMe-LINK1/2
Connector
80 Port Display
LPC
COM Express
Signal Display
Power/Reset/
Sleep/LID control
COM Express
Type Display
Code Review
Control
COM Express
Power Display