DFI HM920-HM86 - Manual (Page 26)

www.dfi .com Chapter 3 Hardware Installation
26
Chapter 3
Installing HM920-QM87/HM86 onto a Carrier Board
1. Use the provided screw to install the heatsink onto the module. First align the mounting
hole on the heatsink with the mounting hole on the module and then secure them with
the provided screw from the bottom side of the module. The module and heatsink
assembly should look like the one shown below.
Mounting hol e
2. Now install the module and heatsink assembly onto the carrier board. The photo below
shows the locations of the mounting holes on carrier board.
3. Insert the provided mounting screws into the mounting holes - from the bottom through
the top of the carrier board.
• To download COM330-B datasheet and manual
Important:
The carrier board (COM330-B) used in this section is for reference purpose only and
may not resemble your carrier board. These illustrations are mainly to guide you on
how to install HM920-QM87/HM86 onto the carrier board of your choice.
Mounting hole
Bottom side of heat sink
Mounting
screw
Top view Bottom view
Mounting hole
Mounting screws
Top view