DFI HM920-HM86 - Manual (Page 27)

www.dfi .com Chapter 3 Hardware Installation
27
Chapter 3
4. While supporting the mounting screw at the bottom, from the top side of the board, fasten
a bolt into the screw.
5. The photo below shows the solder side of the board with the screws already fixed in place.
6. The photo below shows the component side of the board with the bolts already fixed in
place.
7. Position the heat sink on the top of HM920-QM87/HM86 with the heat sink’s mounting
holes aligned with HM920-QM87/HM86 mounting holes. Insert one of the provided long
screws into the mounting hole shown in the photo below.
Long screw
Mounting hole
Bolts
Mounting screw
Bolts