DFI KS230-CD Manual - Manual (Page 29)

www.dfi .com
29
Chapter 4 Ports and Connectors
Chapter 4
VGA
Graphics Interface
The display port consists of the following:
• VGA port
VGA Port
The VGA port is used for connecting a VGA monitor. Connect the monitor’s 15-pin D-shell cable
connector to the VGA port. After you plug the monitor’s cable connector into the VGA port,
gently tighten the cable screws to hold the connector in place.
BIOS Setting
Configure the display device in the Chipset menu (“North Bridge Configuration” submenu) of
the BIOS. Refer to chapter 6 for more information.
Driver Installation
Install the graphics driver. Refer to chapter 7 for more information.
RJ45 LAN Ports
The LAN ports allow the system board to connect to a local area network by means of a
network hub.
BIOS Setting
Configure the onboard LAN in the Chipset menu (“South Bridge Configuration” submenu) of
the BIOS. Refer to chapter 6 for more information.
Driver Installation
Install the LAN drivers. Refer to chapter 7 for more information.
LAN 1
Features
• 2 Intel ® 82574 Gigabit Ethernet Controllers
LAN 2
LAN 1 LAN 2